[. . . ] Always place the appliance on a flat, level and heat-resistant surface during operation. Do not position the appliance on or near hot surfaces or open flames such as hot-plates or gas flames. Always remove the plug from the wall socket - after use, - in case of any malfunction, - before cleaning the appliance. When removing the plug from the wall socket, never pull on the power cord; always grip the plug itself. [. . . ] Filling with water Fill the water reservoir before using the steam function or the spray nozzle. - This steam iron is to a large extent resistant to hard water (up to 15º dH). Although normal tap water may be used, it is advisable to use distilled, demineralised or decalcified water. Should you be unsure about the hardness of the water in your area, please enquire of the relevant local authority department. - This steam iron is to a large extent resistant to hard water (up to 15º dH). This will result in the removal of possible dust particles from the soleplate and subsequently lessen the smell typically encountered when first switching on. The temperature level for steam ironing is indicated on the temperature control knob. - After filling the reservoir with water, place the steam iron upright on its base stand and insert the plug into the wall socket. - Set the temperature control knob to the required ironing temperature as indicated by the ironing symbols. The lamp will go out once the required ironing temperature is reached. — Before ironing any fabrics, the soleplate should be cleaned by passing it over an old, clean cotton cloth, while using the steam jet function; this helps to flush out any dirt residues or lint particles trapped inside the openings in the soleplate. — The steam output can be adjusted with the steam control button or completely switched off for dry ironing. Should there be water left in the reservoir, the steam jet function may also be used when dry-ironing at higher temperature settings. — Place the steam iron upright on its base stand after use and remove the plug from the wall socket. The automatic switch-off is indicated by a beep signal; in addition, the red indicator light flashes. Horizontal position: With the iron standing on its sole plate, it will switch off after approx 30 seconds of inactivity. Vertical position: When upright on its base stand, the iron will switch off after approx. Steam Jet When the steam jet button is depressed, an additional hot steam jet is emitted from the soleplate. This function can be very useful when the regular amount of steam emitted is not sufficient to remove stubborn creases or when ironing difficult or thick fabrics. The steam jet function may also be used with the iron held vertically, to remove creases or wrinkles from fabrics. Using the Spray Nozzle The laundry can be dampened by pressing the spray button. The spray nozzle may be used at any temperature level during dry or steam ironing. [. . . ] — To avoid damage to the soleplate, store the steam iron in upright position on its base stand. Disposal Do not dispose of old or defective appliances in domestic garbage; this should only be done through public collection points. Under this guarantee the manufacturer undertakes to repair or replace any parts found to be defective, providing the product is returned to one of our authorised service centres. This guarantee is only valid if the appliance has been used in accordance with the instructions, and provided that it has not been modified, repaired or interfered with by any unauthorised person, or damaged through misuse. [. . . ]